To Next PageTo Next Page
Need help?Do you have a question about the Stiga CP1 480 Li D48 Series and is the answer not in the manual?
General| Brand | Stiga |
|---|---|
| Model | CP1 480 Li D48 Series |
| Category | Lawn Mower |
| Language | English |
Learn machine controls, proper use, and quick engine stop. Failure to follow warnings may cause fire or injury.
Wear PPE, check work area, and prepare machine before starting work.
Do not use in explosive environments. Avoid rain/wet conditions. Work in daylight or good artificial light.
Ensure regular maintenance and correct storage for safety and performance. Never use with worn/damaged parts.
Use recommended chargers/batteries. Keep unused batteries away from metal objects to prevent short circuits.
Comply with local disposal regulations for packaging, parts, and waste. Recycle electrical equipment.
Details the machine's design, intended use, and examples of improper use.
Lists and illustrates the main parts of the lawnmower, including chassis, engine, cutting means, handle, controls, battery, etc.
Explains various safety symbols and warnings, such as risk of thrown objects, cutting hazards, and electrical safety.
Instructions for unpacking and assembling the machine, including handle adjustment and grass catcher attachment.
Details the function of the safety key, operator presence lever, power button, and drive lever.
Place machine horizontally. Check battery charge before first use and before each use.
Check assembly, fasteners, and cleanliness. Perform test drive to ensure correct operation.
Start on a level surface. Maintain safe distance from cutting device. Empty grass catcher as shown.
Release the switch control to stop the machine. Cutting means stop after a few seconds.
Clean the machine, replace damaged parts, tighten screws. Remove safety key when unused.
Clean thoroughly after each use. Do not spray water on motor/electrical parts. Remove debris from chassis and air intakes.
Do not touch cutting device until safety key is removed and device is stationary. Replace damaged/worn cutting means with original parts.
Recharge the battery as shown in Figure 16.
Stop machine, ensure all moving parts are stopped, remove safety key, disconnect power. Wear gloves, use adequate people, secure for transport.
Wait for motor to cool, remove safety key/battery, clean machine. Store in dry, protected place, inaccessible to children.
