Stiga TRE 0702 - Page 46

Release 00 - 03/2018
pag. 46
Engine TRE 0701-TRE 0702-TRE 0801
Service manual
- Measure the height of the pump cylinder
body (21), which must be lower than 9.95mm.
-
Using a thickness gauge (22), measure the
play between the pump cylinder and its mounting
seat on the sump. The value must not exceed
0.26mm.
13 - Assembling the oil pump, remember to
replace always the seal (8) and x the screws of
the cover to the indicated couple.
14 - Before tting the camshaft ensure that the two
tappets (23) are correctly housed in their seats.
15 - When retting the camshaft, maximum care
must be taken to match up the two references (24)
and (25) punched on the gears, so as to ensure
correct distribution phasing.
16 - During assembly, refer to the operations
in section [ 11.2] always remembering to re-
place the washer (9) between the sump and the
housing.
11. ENGINE BLOCK - Overhauling internal parts
23
23
25
24
8
21
INDEX
<< BACK >>