Stiga TRE 0801 - Petrol Supply and Air Intake

Release 00 - 03/2018
Engine TRE 0701-TRE 0702-TRE 0801
pag. 15
Service manual
IMPORTANT: Carefully read the information below before commencing any intervention.
General information
The petrol supply occurs via a tank mounted on the machine and connected to the carburettor by a pipe.
A lter, positioned between the tank and the petrol pump, stops deposits and impurities from reaching the
carburettor.
Supply to the oat chamber of the carburettor occurs via the petrol pump and the volume of petrol taken
from the tank during operation is compensated by a breather tted in the cap.
See the relevant section [
14] for advice on resolving problems due to the malfunctioning of the petrol
supply system.
WARNING: All interventions on the supply system must be performed in safe conditions, therefore:
- do not smoke;
- workinaventilatedenvironmentawayfromnakedamesorunprotectedsourcesofheat;
- Collect any remaining petrol by positioning a suitable container under the engine, avoiding soiling the
workbench;
- remove all traces of spilt petrol immediately.
5. PETROL SUPPLY AND AIR INTAKE
INDEX
<< BACK >>