Stiga TRE 0801 - Maintenance Of Filtering Element

Release 00 - 03/2018
pag. 16
Engine TRE 0701-TRE 0702-TRE 0801
Service manual
General information
The lteringsystem consists of an air lter directly connected to the carburettor and an internal manifold,
located between the carburettor and the cylinder head, which carries the air/petrol mix towards the intake
valve.
See the relevant section [
14] for advice on resolving problems due to the malfunctioning of the air
intake system.
Aninefcientltercanletdustordebrisenterthecylinder,causingprematureweartothepistonringsand
cylinder.
The air lter is found on the left hand side of the engine and can be inspected without having to remove
other parts.
5. PETROL SUPPLY AND AIR INTAKE
3
3
4
5.1. Maintenanceoflteringelement
WARNING: Never run the engine without air
lter.Theenginewouldcertainlybedama-
ged.
1 - Clean around the lter cover (1).
2 - Unscrew the two screws (1) and remove the
knobs (2).
3 - Remove the lter element (3) and remove the
prelter (4) from the cartridge.
2
2
1
INDEX
<< BACK >>