Stiga TRE 0801 - Carburation; Removing and Cleaning the Carburettor

Release 00 - 03/2018
Engine TRE 0701-TRE 0702-TRE 0801
pag. 21
Service manual
General information
The carburettor has a oat with a xed jet and a “CHOKE” control.
See the relevant section [
14] for advice on resolving problems due to carburation.
The carburettor is located on the left-hand side of the engine. For maintenance operations it is necessary
to dismantle the air intake lter in the sequence shown below.
Dismantle the engine from the machine following the instructions in section [ 11.1].
7. CARBURATION
1
2
3
4
6
WARNING! All operations on the tank and
supply system must be carried out in safe
conditions, so:
- do not smoke;
- always empty the tank if petrol is not strictly
necessary for the operation to be carried out;
- work in a ventilated environment away from
nakedamesorunprotectedsourcesofheat;
- collectpetrolinasuitablecontainerwithacap
usingafunnelandavoidspillingitonthework
bench;
- remove all traces of spilt petrol immediately;
- check you have connected the pipes before
pouring petrol back into the tank.
7.1. Removing and cleaning the carburettor
1 - Remove the complete lter (1) by unscrewing
the nuts (2).
Remove the clamp for the petrol pipe from the side
of the carburettor and use a suitable container to
collect all the petrol in the tank and the pipe.
2 - Remove the washer (3) and lift the carburettor
off (4). Retain washer (5).
3 - Using pliers, remove the tie engine shaft (6) of
the accelerator throttle lever.
5
INDEX
<< BACK >>