BG 50
English
14
N Pull the throttle trigger (2) and hold it
there.
N Crank engine until it begins to fire.
N Set the choke lever (3) to e.
N Pull the throttle trigger (2) and hold it
there.
N Continue cranking until the engine
runs.
If the engine is warm
Also use this setting if the engine has
been running but is still cold.
N Set the choke lever (3) to e.
N Pull the throttle trigger (2) and hold it
there.
N Continue cranking until the engine
runs.
Cranking
N Place the unit on the ground so that
it is secure.
N Make sure you have a firm footing:
Hold the unit firmly with your left
hand on the housing and press
down.
N Hold the starter grip with your right
hand.
N Pull the starter grip slowly until you
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Stopping the Engine
N Move the stop switch to 0
Other Hints on Starting
If the engine stops during warm-up or
acceleration
N Repeat the starting procedure – see
"If the engine is cold".
If engine does not start
N Make sure all settings are correct
(choke shutter, stop switch in run
position I).
N Repeat the starting procedure.
If the engine still does not start
N Move the stop switch to 0
N Remove the spark plug – see
"Spark Plug".
N Dry the spark plug.
N Crank the engine several times with
the starter to clear the combustion
chamber.
N Refit the spark plug – see "Spark
Plug".
N Move the stop switch to I
N set the choke lever to e – even if
the engine is cold.
N Pull the throttle trigger (2) and hold it
there.
N Now start the engine.
To Next Page
Loading...
