Stihl BT 45 - Releasing a Trapped Auger

BT 45
English
20
If the auger jams in the drill hole
N Let go of the throttle trigger so that
the engine returns to idling speed.
N Move rotary knob to R position
(counterclockwise rotation) – it may
be necessary to rotate the machine
a little until the knob can be moved
to the required position.
N Hold the machine firmly with both
hands on the handles.
N Operate the throttle trigger.
N Increase engine speed and slowly
pull the drilling tool out of the drill
hole.
If there is a noticeable loss of engine
power
N Set the choke lever to l.
N Loosen the screw (1).
N Remove the air filter cover (2).
N Clean away loose dirt from around
the filter.
N Take the air filter (3) out of the filter
housing (4).
N Replace with a new filter – or, as a
temporary measure, knock it out or
blow it clear – do not wash.
N Replace any damaged parts.
N Install the filter in the filter housing.
N Fit the filter cover, engage the two
tabs (arrows) at the bottom first.
N Insert the screw and tighten it down
firmly.
Releasing a Trapped Auger
421BA025 KN
Cleaning the Air Filter
421BA026 KN
1
2
3
4
421BA038 KN