STIHL TS 460 16
approx. 130 mm over one full
revolution of the wheel. Refer to
the table "Test procedure".
- Remove the test equipment after
completing the measurement.
3.2 Checking the Axial and
Radial Truth of Running
Top:
Fitting the test wheel
1 = Arresting grooves
1 =Test wheel 5910 851 6100 2 = Arresting lugs
2 = Gauge holder
5910 850 6000 Bottom:
Tightening the V-belt 3 = Dial gauge 0000 890 9100 Test equipment in position
- Place V-belt in V-belt of bearing, Since changes in the shaft
position guard and loosely screw diameter (due to scoring etc.) can
in mounting screws. affect the radial truth of running of
the cutting wheel, it is normally
- Turn hexagon of tensioning sufficient to inspect the shaft
device clockwise until spring around the cutting wheel mount.
force is eliminated.
The axial truth of running, on the
- Tighten all three mounting other hand, depends on the state
screws starting with rear screw. of various components and must
therefore be determined by
measurement.
- Fit the test wheel and then
position the thrust washer so that
the arresting lugs engage in the
arresting grooves in the shaft.
- Tighten the screw.
- Secure the gauge holder with dial
gauge to the guard cover so that
the axial truth of running can be
determined for a diameter of
To Next Page
Loading...
