Stihl Cutquik TS 460 - Axial Truth of Running

STIHL TS 460 17
Test procedure Actual condition Possible causes Remedy
Radial truth of running:
Visual inspection Wear marks or scoring Mounting screw loose, Replace the
of the spindle (shaft) around the cutting wheel use of wrong cutting spindle (shaft)
mount wheels (diameter of
mount Ø > 20 mm
or > 22 mm)
Axial truth of running:
Check the axial truth of Axial eccentricity None
running with the STIHL ≤ 0,15 mm
test wheel or diamond
cutting wheel (over a > 0,15 mm
diameter of 130 mm) Damaged or uneven contact Dirt; thrust washers or Replace the
surfaces of the thrust washers cutting wheel fitted incorrectly; thrust washers
(especially the inner thrust application of force when
washer); contact surfaces not cutting or during transport
plane; genuine STIHL parts
have not been used
Spindle (shaft) Incorrect handling, Replace the
damaged use of force spindle (shaft)
Distinct radial play in the Deep groove ball bearings Replace the
bearing seat --> spindle damaged by exposure to dirt spindles and
bearing defective and/or bearing seat worn deep groove
down at the spindle ball bearings