Stihl Cutquik TS 460 - Installation

STIHL TS 460 24
5.2.2 Installation
Use the installing tool as
folllows:
- Remove the sleeve from the
tool.
- Attach the snap ring to the
magnet so that the snap
ring gap is on the flat side
of the tool's shank.
- Thoroughly clean the gasket
seating surface on the
cylinder. Lubricate the
needle cage with oil and fit it
in the small end.
- Mount spacer flange with
new gasket on cylinder,
insert screws and tighten to
10 Nm.
Top:
Needle cage in connecting rod
Bottom:
1 = Arrow on
piston head
2 = Fan cover
Installing piston pin
Top:
1 = Installing tool 5910 890 2212
2 = Sleeve
Bottom:
1 = Snap ring (hookless)
2 = Magnet
- Heat the piston on an
electric heating plate to
approx. 60 °C and slip it
over the connecting rod so
that the arrow on the
piston head points to the
left (looking at fan cover).
- Push the assembly drift,
small diameter first, through
the piston and small end
(needle cage) and line up the
piston.
- Fit the piston pin on the
assembly drift and slide it into
the piston (the pin
slides home easily if the
piston is hot).
- Fit the wire snap rings.
Note: Use installig tools to fit the
snap rings.