STIHL TS 460 31
5.5.1 Preparations
Top:
1 = Test flange 1119 850 4201
2 = Bushings 0000 963 20008
3 = Screws 9043 319 8100
Bottom:
Test flange fitted
- Remove the carburetor,
see 10.3.
- Remove the deflector baffle
from the muffler, then remove
the spark arresting screen,
see 5.1.
- Remove the outer
mounting screws from the
muffler.
- Back off the muffler's
inner mounting screws half-way.
- Slide the sealing plate
between the muffler and the
cylinder exhaust port and
retighten the inner mounting
screws moderately.
Note: The sealing plate must
completely fill the space
betwen the two mounting
screws.
- Set the piston to top dead
center (T.D.C.).
- Attach the test flange
with bushings and screws
to the spacer flange for
leakage testing.
Important! A new carburetor
gasket must be installed
between the test flange and the
spacer flange.
Top:
Sealing plate 0000 855 8106
Bottom:
Sealing plate fitted
Top:
Outer mounting screws of exhaust
muffler
Bottom:
Inner mounting screws of exhaust muffler
To Next Page
Loading...
