Stihl Cutquik TS 460 - Page 36

STIHL TS 460 36
Top:
Carburetor box cover
mounting screws
Bottom:
Withdrawing the grommet
Top:
1 = Nipple of throttle cable
2 = Slotted pin
Bottom:
Throttle cable
mounting screw
Top:
Manifold clamp
Bottom:
Choke shutter
- Remove carburetor box cover
mounting screws, remove
carburetor box cover.
- Withdraw grommet from
mounting in engine housing.
- Disconnect nipple of throttle
cable from slotted pin on
throttle lever.
- Remove throttle cable
mounting screw and press
throttle cable out of the
machine sideways.
- Loosen screw of manifold
clamp and pull manifold off of
connector.
- Remove choke shutter from
its mounting in engine housing.