Stihl Cutquik TS 460 - Page 37

STIHL TS 460 37
Top:
Compensator hose
Bottom:
Outer muffler mounting
screws
Top:
Flywheel
Bottom:
Connecting piece
mounting screws
Top:
Crankcase mounting
screws
Bottom:
Fuel hose
- Pull compensator hose off
of angle connector.
- Remove outer muffler mounting
screws.
- Remove flywheel, see 6.1.5.
- Remove clutch, see 4.1.
- Unscrew connecting piece
mounting screws, remove
connecting piece.
- Remove expansion tank,
see 10.9.
- Remove crankcase mounting
screws.
- Lift engine slightly and pull fuel
hose off of angle connector.