Stihl Cutquik TS 460 - Page 39

STIHL TS 460 39
Top:
Pressing out the grommet
Bottom:
Main filter
Top:
Removing the auxiliary filter
1 = O-ring
Bottom:
Filter base mounting
screws
Top:
Removing the manifold
Bottom:
1 = Mounting screw
2 = Ground wire
3 = Point of separation of short circuit wire
- Remove handle tube bracket,
see 9.6.
- Press grommet for short circuit
wire out of engine housing and
pull out short circuit wire.
- Remove filter cover.
- Remove main filter and prefilter
from filter base.
- Remove auxiliary filter from
fitting.
- Remove O-ring from locating
pin.
- Remove filter base mounting
screws, remove filter base.
- Remove manifold from engine
housing.
- Unscrew mounting screw of
ground wire.
- Pull short circuit wire apart at
point of separation.