Stihl Cutquik TS 460 - Short Circuit and Ground Wires

STIHL TS 460 47
6.1.4 Short Circuit Wire
/
Ground Wire
Top:
Separating point of short circuit wire
Bottom:
Grommet
Top:
Ground wire
Mounting screw
Bottom:
Properly positioned short circuit wire
and ground wire
- Remove fan housing, see 6.1.5.
- Remove expansion tank,
see 10.9.
- Remove short circuit wire
from connection on ignition
module and pull wire out of
wire holder.
- Press grommet out of engine
housing and pull out short
circuit wire.
- Pull short circuit wire apart at
separation point in carburetor
box.
- Pull grommet out of engine
housing and remove short
circuit wire.
- Unscrew ground wire mounting
screw in carburetor chamber.
- Remove fuel tank, see 10.8.
- Remove contact springs, see 9.3.
- Remove short circuit wire and
ground wire from handle grip.
The parts are assembled in reverse
order.
Note: Position both wires in the handle
grip correctly.
Top:
1 = Short circuit wire
2 = Wire holder
Bottom:
Grommet