Stihl Cutquik TS 460 - Throttle Control; Throttle Trigger and Interlock

STIHL TS 460 56
9. Throttle Control
9.1 Throttle Trigger,
Throttle Trigger Interlock
Top:
Mounting screws of handle molding
Bottom:
Torsion spring
Top:
Removing the throttle interlock
Bottom:
Removing the throttle trigger
Detaching throttle cable from
throttle tri
gg
e
r
- Detach nipple of throttle cable
from throttle trigger.
The parts are assembled in
reverse order.
Note: Tighten mounting screws of
handle molding to 3.0 Nm.
- Unscrew mounting screws of
handle molding, remove
handle molding.
- Disconnect torsion spring
from throttle trigger and
throttle interlock and remove
from pin.
- Remove throttle interlock from
pin.
- Remove throttle trigger from
pin.