Stihl Cutquik TS 460 - Page 64

STIHL TS 460 64
Top:
Choke knob
Bottom:
Unscrewing the carburetor mounting
screws
1 = Mounting screws
2 = Opening in connecting piece
Top:
Removing the connector
Bottom:
1 = Fuel hose
2 = Compensator hose
Top:
Gaskets
Bottom:
1 = Pin
2 = Choke lever
- Remove choke knob from
mount in engine housing.
- Remove carburetor mounting
screws through openings in
handle grip and connecting
piece.
- Lift the carburetor and
connector slightly and remove
the connector and mounting
screws from the carburetor.
- Disconnect fuel hose and
compensator hose from angle
connectors.
The parts are assembled in
reverse order.
Note: Slide new gaskets over
mounting screws on both sides of
carburetor.
Tighten mounting screws to
5.0 Nm.
Fit choke shutter so that pin
engages choke lever.