Stihl Cutquik TS 460 - Page 69

STIHL TS 460 69
Top:
Throttle shutter fastening
screw
Bottom:
1 = Washer
2 = Circlip
Top:
Removing the throttle shaft
Bottom:
1 = Lever on the throttle shaft
2 = Slotted pin
3 = Circlip
Top:
1 = Bushing
2 = Torsion spring
Bottom:
Properly positioned torsion spring
Removing the throttle shaft:
- Unscrew the throttle shutter
fastening screw.
- Use suitable pliers to pull
the throttle shutter out of
the carburetor.
- Press circlip off of throttle
shaft and remove washer.
- Carefully pull throttle shaft out
of carburetor.
- Remove torsion spring and
bushings.
- Press circlip off of slotted pin,
remove slotted pin from
throttle shaft lever.
- Slide bushings and torsion
springs onto throttle lever.
Note: Slide bushings on so that in
each case the end with the smaller
diameter faces the torsion spring.
- After sliding in the throttle shaft,
make sure that the torsion
springs are positioned properly.