FSE 60, FSE 71, FSE 81
English
46
N Straighten out the nylon lines and
wind them tightly on to the spool –
one nylon line in each chamber.
N Engage the ends of the lines in the
notches (5).
Assembling the mowing head
NOTICE
Check that the spring is installed (see
"Mounting the Cutting Attachment").
N Thread the ends of the lines (6)
through the sleeves (7) and push
the spool (2) into the head so that it
snaps into position.
The nylon lines must disengage from the
notches (5) as the spool is pushed into
position.
N Pull out the ends of the lines as far
as stop.
N Mount the mowing head on the
machine.
To Next Page
Loading...
