Stihl GS 461 - Page 35

GS 461
English
33
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
Engine
STIHL single cylinder two-stroke engine
Ignition System
Electronic magneto ignition
This ignition system meets all
requirements of the Canadian
Interference-Causing Equipment
Regulations ICES-002.
Fuel System
All position diaphragm carburetor with
integral fuel pump
Weight
Cutting Attachment (GS 461)
Rollomatic G guide bar
3/8" diamond abrasive chain
Chain Sprockets
– Check gauges
– STIHL grease
– STIHL filling system for fuel –
prevents spillage or overfilling
during filling
– Guide bar straightener
Ask your STIHL servicing dealer for
current information about this and other
special accessories.
Specifications
A = 300 hours
B = 125 hours
C = 50 hours
Displacement: 76.5 cm
3
Bore: 52 mm
Stroke: 36 mm
Engine power to
ISO 7293:
4.3 kW (5.8 HP)
at 9,800 rpm
Idle speed: 2,500 rpm
Cut-off speed: 13,500 rpm
Spark plug (resistor
type):
Bosch WSR 6 F,
NGK BPMR 7 A
Electrode gap: 0.5 mm
Fuel tank capacity: 0.78 l
Weight (dry, without bar and
chain): 7.6 kg
Bar lengths (3/8"
pitch): 40 cm
Groove width: 1.6 mm
36 GBM, Type 3210
Pitch: 3/8" (9.32 mm)
Drive link gauge: 1.6 mm
8-tooth for 3/8" (rim sprocket)
Special Accessories