41MS 460, MS 460 C
– Wait for crankcase to cool down.
: Push the stop buffer into the
guide so that its lugs are behind
the housing rib.
VA
176RA126
: Push the two annular buffers,
tapered end first, into position so
that their annular grooves (1)
engage the housing rib (2).
: Install the suction hose, b 11.1
VA
176RA127
2
1
: Screw spindle of service tool ZS
(2) 5910 007 2200 fully home
and then screw the threaded
sleeve (1) 5910 893 2420 onto
the spindle.
VA
176RA128
1
2
– Lubricate tapered stub of
crankshaft with oil.
: Place tapered stub of crankshaft
in ball bearing at the flywheel side
of the crankcase.
VA
176RA129
: Screw threaded sleeve (1) to
thread (2) of crankshaft stub.
VA
176RA130
21
: Hold the spindle steady and
rotate the service tool counter-
clockwise until the drilled plate
butts against the crankcase.
VA
176RA131
: Turn the spindle clockwise until
the crankshaft locates against the
ball bearing.
The connecting rod must point
toward the cylinder flange while the
crankshaft is being installed.
VA
176RA132
To Next Page
Loading...
