MS 650, MS 660
English
32
Install spark plug
N Screw in the spark plug and press
on the spark plug boot
N Install air baffle
N Mount carburetor box cover
Removing the fan housing
N Remove screws (1)
N Push hand guard upward
N Pull the bottom of the fan housing
away from the crankcase and
remove downwards
Replace torn starter rope
N Carefully press the spring clip (2) off
of the axle with a screw driver or
suitable pliers
N Carefully remove the rope rotor with
washer (3) and pawl (4)
N Lever the rope out of the starter
handle with a screwdriver
N Remove the remainder of the rope
from the rotor and starter handle
N Thread a new starter rope from top
to bottom through the handle and
rope guide bush (5)
N Thread the rope through the rotor
and secure it in the rotor with a
simple overhand knot
N Coat the bearing bore in the rope
rotor with non-resinous oil
N Slip the rope rotor onto the starter
post – turn it back and forth a little
until the anchor loop of the rewind
spring engages
If the spark plug comes with a
detachable adapter nut (1), screw
the adapter onto the thread and
tighten it down firmly to reduce
the risk of arcing and fire.
To Next Page
Loading...
