EasyManua.ls Logo

Stihl RLE 240 - Safety Information for Lawn Scarifiers; Introduction; Training; Preparation

Stihl RLE 240
312 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
0478-670-9910-A
48
English
19 Specifications
19.1 STIHL RLE 240.0 Lawn Scarifier
Power supply: See rating plate
Frequency: See rating plate
Power input: 1500 W
Weight: 16 kg
Maximum grass catcher box capacity: 50 l
Working width: 34 cm
Speed: 4100 rpm
Working depth: Infinitely variable, adjustment range
15 mm
Electrical protection class: II
Electrical type of protection: IPX4 (protection against high
levels of dust but not dust proof; splash proof from all
angles)
19.2 Rollers
Scarifying roller
20 fixed blades
Combing roller
11x2 moving spring-tines
19.3 Extension Cords
If an extension cord is used, it must have a ground wire and
the wire gage of its conductors must meet the following
minimum requirements – depending on the line voltage and
length of the extension cord:
If rated voltage on the rating label is 220V to 240V:
Cord length up to 20 m: AWG 15 / 1.5 mm²
Cord length 20 m up to 50 m: AWG 13 / 2.5 mm²
If rated voltage on the rating label is 100 V to 127 V:
Cord length up to 10 m: AWG 14 / 2.0 mm²
Cord length 10 m up to 30 m: AWG 12 / 3.5 mm²
19.4 Sound Values and Vibration Values
The K value for the sound pressure level is 3 dB(A). The K
value for the sound power level is 4.7 dB(A). The K value for
the vibration values is 2.08 m/s².
Sound pressure level L
pA
measured in accordance with
EN 50636-2-92: 79 dB(A)
Sound power level L
wAd
measured in accordance with
2000/14/EC: 95 dB(A)
Vibration value a
hw
measured in accordance with EN
20643, EN 50636-2-92, handlebar: 5.2 m/s²
The indicated vibration values have been measured in
accordance with a standardised test method and can be
used for the purpose of comparing electrical appliances. The
actual vibration values that occur may deviate from the
indicated values, depending on the type of application. The
indicated vibration values can be used for an initial
assessment of the vibration load. The actual vibration load
must be assessed. Times during which the electrical
appliance is switched off, along with times in which it is
switched on but running without load, can also be taken into
consideration.
For information on compliance with Employers' Vibration
Directive 2002/44/EC see www.stihl.com/vib.
19 Specifications
1
2
0000-GXX-B685-A0

Table of Contents

Related product manuals