Stihl TS 500i - Page 109

108 TS 500i
: Pull the hose (1) out of the
crankcase (arrow)
– Check the hose, replace if
necessary
Installation
: Push the hose clip (1) over the
shoulder of the manifold (2) in the
direction of the throttle shutter
housing so that the screw head
faces the clutch side
– Apply STIHL press fluid to the
inside of the manifold, b 13
1307RA361 TG
1
1307RA227 TG
1
2
– Use STIHL press fluid to simplify
assembly, b 13
: Slide the hose (1) into the recess
(arrow) in the crankcase and then
push it into the opening (2) in the
side of the fan-side half of the
crankcase.
: Check that the hose is correctly
seated
– On the fan side, the hose
(arrows) must enclose the
opening completely
: Slide the sleeve (1) into the
opening (arrow) in the hose
until it lies flush
1307RA110 TG
1
2
1307RA228 TG
1307RA229 TG
1
: Note the position (arrow) of the
sleeve (1)
Fitting a new hose
– Use STIHL press fluid to simplify
assembly, b 13
: Position the tank housing (1) on
the crankcase from below
: Guide the hose (2) through the
opening (arrow) in the tank
housing with the tab
– Hold the tank housing in place
1307RA230 TG
1
1307RA231 TG
2
1