Stihl TS 500i - Page 110

109TS 500i
: Pull the hose (1) into the tank
housing with the tab (2) until the
hose completely encloses the
opening (arrow)
– Cut off the tab (2)
Fitting an existing hose
– Use STIHL press fluid to simplify
assembly, b 13
: Position the tank housing (1) on
the crankcase from below
: Lay a piece of string (approx.
30 cm) around the hose (2)
(single loop) and guide the ends
of the string through the opening
(arrow) in the tank housing (1)
– Hold the tank housing in place
1307RA232 TG
1
2
1307RA233 TG
2
1
: Pull the hose (1) into the tank
housing with the ends of the
string (2) until the hose
completely encloses the opening
(arrow)
– Remove the string
Bearing plug (1) must be twisted
into the antivibration spring as far as
it will go.
: Push the tank housing with
bearing plug (1) into the mount
(arrow) and hold it in position
: Screw in the screw (1) and
tighten it
1307RA234 TG
1
2
1307RA331 TG
1
1307RA235 TG
1
: Push the manifold (1) completely
and evenly onto the
supports (arrow) of the tank
housing until it is in the groove on
the circumference
– Push the hose clip over the
shoulder of the manifold
: Align the hose clip (1) on the
manifold (3) so that the clamping
gap lines up with the fin (arrow)
: Screw in the screw (2) and
tighten it
1307RA236 TG
1
1307RA237 TG
1
2
3