112 TS 500i
No. Designation Part No. Use Re-
marks
9 Bit T 27 x 125 0812 542 2104 Removing and installing spline socket
head screws with electric or pneumatic
screwdrivers; tightening down screws
with torque wrench
10 Wooden assembly block 1108 893 4800 Positioning piston
11 Assembly sleeve 1118 893 4602 Protect oil seal on clutch side
12 Press sleeve 1122 893 2405 Press in oil seal on fan side
13 Assembly sleeve 1141 893 4600 Protect oil seal on fan side
14 Press arbor 4119 893 7200 Drive grooved ball bearing out of poly
V-belt pulley
15 Plug 4221 025 2200 Leakage testing (on decompression
valve)
16 Press arbor 4224 893 7200 Press ball bearing in spindle bearing
and belt pulley
17 Clamping plate for cut-off
machine
4238 890 2100 Mount cut-off machine on assembly
stand
18 Press sleeve 4238 893 2400 Install oil seal on clutch side
19 Spacer 4238 894 1100 Release flywheel in combination with
extractor 5910 890 4504 to protect the
generator
20 Service tool ZS 5910 007 2201 Remove and install crankshaft
– Washer 5910 893 2103 Remove crankshaft / fan side
– Washer 5910 893 2101 Remove crankshaft / clutch side
21 Mount for assembly stand 5910 850 1650 Fit mount on assembly stand
22 Test disk 5910 851 6100 Test axial truth of running of the cutting
wheel mount
23 Torque wrench 5910 890 0302 Screw connections (0.5 to 18 Nm)
(with visual and acoustic signaling)
24 Torque wrench 5910 890 0312 Screw connections (6 to 80 Nm)
(with visual and acoustic signaling)
25 Assembly tool 12 5910 890 2212 Fit hookless snap rings in piston
- Sleeve 5910 893 1706 For assembly tool, 12
26 Screwdriver T 27 x 150 5910 890 2400 1)
To Next Page
Loading...
