Stihl TS 500i - Shroud

46 TS 500i
Installation
– Clean the mating surface, b 13
– Grease the sealing lips of the
new oil seal, b 13
– Fit the assembly sleeve (1)
1118 893 4602.
: Slide the oil seal (2) over the
assembly sleeve with the sealing
lip facing the crankcase
– Remove the assembly sleeve
: Use the press sleeve (1)
4238 893 2400 to install the oil
seal (2)
The seating face must be flat and
free from burrs.
– Reassemble remaining parts in
reverse order
1307RA074 TG
1
2
1307RA075 TG
1
2
6.4 Shroud
: Remove the screw (arrow)
– Screw remains in cap (1)
: Remove the cap (1) with screw
: Unscrew screw (1) and remove
cover (2)
– Screw remains in cover (2)
1307RA050 TG
1
1307RA076 TG
1
2
– Remove dirt from around the plug
on the control unit before
removing it
: Press lock (arrow) downwards by
hand and push out plug (1)
– Do not pull out the plug (1) by
the wires, do not use tools
: Unscrew screw (1) and remove
handle molding (2)
: Unhook the throttle cable (1)
from the throttle trigger (2),
holding the throttle trigger (2) in
place
1307RA077 TG
1
1307RA078 TG
1
2
1307RA079 TG
1
2