Stihl TS 500i - Control Panel

74 TS 500i
: Align the wiring harness (1) of the
switch so that the mark on the
protective tube lines up with the
guide (arrow) and the plug (2) is
outside of the opening
– Install interlock lever and throttle
trigger, b 10.2
– Install switch shaft, b 10.1
: Check correct functioning
– The stop switch must actuate
the contact springs (arrow) of the
switch when in position "STOP"
or "0" and close the contact – this
can be heard as a clicking noise
from the micro switch
The switch shaft can only be set to
position "F" if the trigger interlock
and throttle trigger are pressed.
– Reassemble remaining parts in
reverse order
1307RA309 TG
12
1307RA310 TG
7.7 Control panel
– Check the control panel with
STIHL MDG 1, b 7.1, b 7.2
– Refer also to troubleshooting
chart, b 3.5
– Remove shroud, b 6.4
– Remove switch shaft, b 10.1
– Remove interlock lever and
throttle trigger, b 10.2
: Unscrew the screw (1) and lift the
holder (2) and switch out of the
mount
: Pull the blue and black lead out of
the guides (arrows) and set aside
the switch
1307RA293 TG
2 1
1307RA294 TG
: Pull the plug connections (1)
and (2) out of the guides (arrows)
– Disconnect the plug connections
: Pull the green and yellow lead out
of the guides (arrows)
: Unhook the yellow and green
lead out of the guides (arrows) on
the inside
1307RA295 TG
1
2
1307RA311 TG1307RA312 TG