Stihl TS 500i - Page 94

93TS 500i
: Guide the throttle trigger (1) past
the switch shaft (arrow) and place
it in the shroud with the torsion
spring
: Insert the drift in the hole (arrow)
to secure the throttle trigger with
torsion spring
: Fit the pin (1) and drive it in until
it is at the same distance on both
sides
: Press the trigger interlock (1) into
the bearing points (arrows) until it
clicks into place
1307RA249 TG
1
1307RA250 TG
1
1307RA251 TG
1
: Hook the torsion spring (1) into
the trigger interlock (arrow)
– Install the handle molding,
b 10.1
– Checking correct functioning
– in position "STOP" or "0" the
switch shaft must actuate the
switch
The switch shaft can only be set to
position "F" if the trigger interlock
and throttle trigger are pressed.
1307RA252 TG
1