74 75
Art. 1247
Electric Backpack Sprayer 15 l LI-ION Trolley
Art. 1247
Electric Backpack Sprayer 15 l LI-ION Trolley
For further information about the product, please contact info@stockergarden.com
Sign up to our newsletter and keep up to date with our latest news info@stockergarden.com
After every spraying operation, the sprayer shall be cleaned to avoid corrosion of tool and
blocking of sprinkler caused by pesticide liquid. In addition, the cleaning can also avoid reducing
the effects of spraying operation or bringing harm to crops when the residue of the pesticide is
different from that of the pesticide of next operation.
Clean the surface of the sprayer with a wet cloth. Shake the sprayer after filling it with water,
and then turn on the power switch to spray the cleaning water through the nozzle. Switch
strainer and spray tank strainer can be disassembled for cleaning with water.
Cleaning and maintenance
The sprayer should be stored in a dry indoor place out of reach of children. Do not keep it upside
down for a long time, which may damage the battery.
Storage
Troubleshooting
Problems Causes Solutions
The motor fails to run after
being powered on
1. The pump pressure has
been set at the minimum
value
2. Fuse burn-out
3. Battery out of power
4. Power switch has been
damaged
5. Power wires come off
6. Motor damaged
1. Turn the knob clockwise
to increase the pressure
2. Replace
3. Recharge
4. Replace the switch
5. Disassemble the base to
reconnect the wires
6. Replace the motor
Abnormal sounds heard
while the motor rotates
1. The fastening screws of
pump are loosen
1. Tighten the screws
Leakage occurs to the
underside of the base
1. The inlet and outlet pipes
of the pump are loosen or
broken
1. Disassemble the base to
tighten the pipe clam; repair it
Poor atomization results
1. Extra-low pump pressure
2. The holes inside the
sprinkler sheet are
blocked
3. The spraying hole and
split sheet wears out
4. The spraying sheet has
been inversely assembled
5. Pipe joints may be loosen
6. Battery short of power
1. Turn the knob clockwise
to increase the pressure
2. Remove the impurities
3. Replace the sheets
4. Correct it
5. Tighten the joint
6. Recharge the battery
To Previous Page
Loading...
