68 69
Art. 432
Geyser Nebulizer E-25 MI 21 V
Art. 432
Geyser Nebulizer E-25 MI 21 V
For further information about the product, please contact info@stockergarden.com.
Users can assemble their own tube by adding the foreseen nozzles:
1. Cut the tube at the points where you want to apply a nozzle
2. Insert the tube into the attachments of the quick connector
3. Insert the nozzle on the connector
4. To detach the tube from the quick connector, press the end ring of the connector and pull
the tube out.
1. Remove a nozzle from the nebulizer: press the ring of the connector on which it is inserted,
then pull out the nozzle.
2. Connect the tube directly to the attachment previously used for the nozzle.
3. Close the end attachment of the quick T-connector of the tube with one of the plastic caps
provided.
Assembly and useAssembly and use
Tripod - Art. 413
The tripod is already included in the package of Art. 432 - Geyser
Nebulizer E-25 MI 21 V.
The tripod is a practical accessory for lifting the nebulizer 49 cm
off the ground and conveniently holding it at strategic points in
green areas. To assemble the tripod, screw the 3 aluminium poles
one by one onto the underside of the nebulizer, where there are 3
threaded holes.
Side handles
The side handles facilitate transport and lifting, even when fully
loaded.
Assembly
Connecting the tube to the nebulizer
How to assemble the tube
2
4
1
1 2 3
3
To Next Page
Loading...