Pruning shears Kantia E-22 TR Pruning shears Kantia E-22 TR
For further information about the product, please contact info@stockergarden.com
Art. 309 Art. 309
134 135
Usage
Usage
The blades of the pruner should not be moved around while cutting, so as not to
damage the blades. Never move the pruner side to side when wedged.
1. If the pruning shears stop working after extended use and you hear eight fast beeps, it is an
indication of undervoltage protection, which means that the battery needs charging. Rechar-
ge as soon as possible.
2. In order to conserve the use of battery power and ensure that the pruning shears have the
longest service life, do not overload the device and avoid cutting branches with a diameter
larger than 25 mm.
3. During the shearing process, if the shearing knife encounters a branch that cannot be cut off,
then release the trigger to reopen the blades, after which the next normal shear session can
be carried out.
LED Description
4 green LEDs 100% Battery Charge
3 green LEDs + 1 red LED Charge greater than or equal to 75%
2 green LEDs + 2 red LEDs Charge greater than or equal to 50%
1 green LED + 3 red LEDs Charge greater than or equal to 25%
4 red LEDs Charge less than or equal to 10%
Checking the battery charge level
The pruning shears have 4 easy-to-read LED indicators around
the power button.
When all 4 LEDs are red, the battery needs to be recharged
Audible tone notiļ¬cations
Beeps Interval Frequency Description
1 time 1.5 seconds Not repeating ON
1 time 0.9 seconds Not repeating OFF
1 time 1.0 seconds Not repeating 16 mm opening width set
2 times 1.5 seconds Not repeating 22 mm opening width set
2 times 1.5 seconds Not repeating Security lock/unlock
1 time 0.5 seconds Not repeating
OFF - automatic shutdown after
3 minutes of non-use
3 times Not repeating Defective PCB - PCB needs replacing
5 times Not repeating Overcurrent - PCB needs replacing
8 times Not repeating Low voltage - Recharge the battery
9 times Not repeating
High PCB temperature - Stop the tool
and let it cool down
14 times Not repeating Excessive voltage - replace the battery
After 2 year of intensive operation, we recommend a comprehensive inspection and
maintenance of the shears. Please contact your local reseller.
When carrying out cleaning and maintenance operations, always make sure that the
shears are switched off, the battery is disconnected and the blades are closed.
To Next Page
Loading...