Stocker Kantia E-22 TR - Page 73

Pruning shears Kantia E-22 TR Pruning shears Kantia E-22 TR
For further information about the product, please contact info@stockergarden.com
Art. 309 Art. 309
144 145
Troubleshooting
11
Problems Causes Solutions
Shears will not start
1. The battery is out
of power
2. The battery is
not connected
3. Safety lock of the blade
cannot be unlocked
4. On/off switch failure
1. Charge the battery.
Instructions on page 131
2. Check that the battery is inserted
correctly. When connected correctly,
it makes a „click“ sound
3./4. Send to repair service center by
local authorized reseller or Stocker Srl
Intermittent operation
1. Loose internal
connections
2. On/off switch failure
1./2. Send to repair service center
by local authorized reseller or
Stocker Srl
Hot blades
1. The blade is not sharp
2. There is a gap between
blades
3. Poor lubrication, resulting
in excessive friction
1. Sharpen the blade or replace it.
Instructions on how to sharpen the
blade on page 141, on how to replace
the blade on page 137.
2. Adjust the gap between the
blades. Instructions on page 141.
If the adjustment doesn‘t solve
the problem, replace the blade.
Instructions on how to replace the
blade on page 137.
3. Carry out the lubrication process.
Instructions on page 136.
Problems Causes Solutions
Poor trimming
performance
1. Poor lubrication,
resulting in excessive
friction
2. The blade is dirty
3. The blade is not sharp
4. Incorrect trimming
tecnique
5. The battery is not fully
charged
1. Carry out the lubrication process.
Instructions on page 136
2. Clean the blade. Instructions on page 136
3. Sharpen the blade or replace it.
Instructions on how to sharpen the blade
on page 141, on how to replace the blade
on page 137.
4. Carefully read operating instructions
in the “Usage“ section.
5. Check the battery charge level.
Instructions on page 134
The battery will not
charge. Charger
red light flashes.
1. The battery is not properly
connected to the charger
2. The battery charger is
not connected properly to
the power supply
3. The contact point of the
battery or of the battery
charger is dirty
4. Defective or damaged
battery or battery charger.
1. Check that the battery is properly
connected to the charger. You hear a
„click“ when it is connected correctly.
2. Connect correctly
3. Clean with a dry cloth
4. Try to charge both batteries with
the same battery charger. If only one
works, the other battery is defective or
damaged. If none of the two batteries
gets charged, the battery charger is
defective or damaged. Contact your
local authorized reseller or Stocker Srl
for spare parts.
Troubleshooting
11
For assistance and service, please contact your local authorized reseller or Stocker Srl.