PRE-DELIVERY INSTRUCTIONS
INTRODUCTION
The purpose of this section of
the manual is to ensure the
dealer makes the necessary
installations, adjustments and
checks, before the machine is
operational. This begins upon
receiving the crated mower and
is finalised once the mower has
been sold. This is the minimum
amount of work required;
however it should not be limited
to the areas detailed in this
procedure.
RESPONSIBILITY
It is the responsibility of the
dealer to ensure that before a
machine is delivered to a
customer, it is in satisfactory
operational condition.
PROCEDURE
1. UNPACK PARTS
Check parts supplied within
plastic bag in seat protection
bag against the following list:
1 Owner/Operators Manual
1 Engine Owners Manual
1 Steering wheel Assembly
(SW14H)
1 Tube spanner AM006C1)
1 Tommy bar (AM007)
1 Spark plug tube spanner
(AM295)
1 Spark plug tube spanner
tommy bar (AM296)
1 Ignition key set (90134)
2 Clutch clearance gauges
(13126)
1 Spring pull hook (13127)
1 Pin (DP10)
2. ASSEMBLE
TOOLS & EQUIPMENT
REQUIRED:
Socket set containing 13mm &
10mm a/f sockets & extension
75mm (3”) or longer. Spanners,
10mm & 13mm a/f. 5mm Allen
key. Hammer & 6mm or 1/4”
pin punch. Battery charger 12V,
4 or 8amp.
SEAT
Remove the four fasteners
attached to the seat then re-
attach the bolts through the
seat mount as per pictorial
procedure provided.
STEERING WHEEL
To attach the steering wheel,
align the hole in the steering
wheel boss to the hole in the
steering shaft and use a
hammer and suitable punch to
drive the DP10 roll pin in,
through the hole in the
steering shaft cover into the
steering wheel and shaft.
Ensure that the pin is situated
centrally in the steering wheel
boss and that the steering is
free to turn.
PRE-DELIVERY
ELECTRIC’S
HOURMETER
Connect the black negative wire
to the terminal supplied at the
back of the hourmeter.
NOTE -The Hourmeter will
continue to operate if the
ignition switch is on.
BATTERY
(If unused for 3 months or
more)
a) Remove R.H Side cover and
rear console cover, then remove
battery retaining bracket.
b) Remove battery from mower
and place on level surface.
c) Using a 12V, 4 or 8amp
battery charger, charge the
battery for a period of 30
minutes.
After charging proceed as
follows:
Install the battery caps.
Allow battery to stand for 30
minutes.
Check acid levels in all battery
cells (top up if necessary).
d) Place charged battery back in
the battery location tray with
terminals towards the right
hand side of the mower. Install
the red battery lead on to the
positive terminal first, and then
the black battery lead on to the
negative terminal.
e) Refit the battery retaining
bracket and re-fit covers.
MOWING
ATTACHMENT
DEFLECTOR
Using a suitable spring hook,
position deflector spring from
the under side of the deflector
for the correct safety operation.
To Next Page
Loading...