C—ROOF COVER INSTALLATION
NOTE: DO NOT install the cover onto the frame of your building in high wind conditions. A
slight breeze is the most advantageous for cover installation. To take advantage of the breeze, pull
the cover up over the arches with breeze blowing in the cover like a sail filled with air.
1. Assemble Tensioning Tube for Roof Cover (No.10) before installing the cover.
2. Put the Roof Cover (No. 13) EVENLY, CAREFULLY AND SLOWLY on the frame. Adjust
the cover so that it is square and evenly centered on the frame.
.
Figure 5
To Next Page
Loading...
