ANCHORING THE CONTAINER
Make sure you have:
Welder.
Cement.
Four 3” x 3” x 6 feet ¼” Square steel angle
1. As shown in the diagram 1, make a 3 ft deep hole right beside one of the front and opposite rear corners of
the container, in which the 6ft square steel will be installed.
2. Insert the 6ft square steel into the hole, making sure 3ft is below the surface completely laying on the side
of the containers.
3. Weld the square steel to the 2 containers.
4. Pour cement in the holes to make sure the square steel won’t move.
5. Repeat the previous steps on the corners located in the opposite rear side.
Securing the containers to the floor is crucial, that way the containers won’t shift under harsh weather
conditions, thus avoiding the shipping container canopy roof top of getting damaged.
Diagram 1
To Next Page
Loading...