Need help?Do you have a question about the Storno CQM6113 and is the answer not in the manual?
Basic mode: Receive/transmit on split frequency, channel scanning at reception.
Set the channel number; program enters this mode via "CH" key.
Enter frequency for RX/TX by channel via "Queue" key.
Receive/transmit at current frequency, scanning frequency interval.
Entered/left by 'S' key; uses Volume keys for channel/frequency navigation.
Opens squelch only on correct ID; configure ID and codec.
Functions for On/Off, Speaker, Volume Up/Down, CH, Mode Selector.
Functions for S, CL, and Queue keys.
Keys for simplex mode, mic/aux input, and tone transmit.
Keys for frequency swap, Selective Call activation, and configuration.
Setting HF transmit power between 5 and 20 watts.
Adjusting frequency differences and squelch threshold.
Setting the lowest audio volume level for reception.
Lists 16 repeater channels RX/TX, numbered 00-15.
Lists marine channels, numbered 00-40 and 60-99.
Pin assignments for Battery +12V and Battery Ground.
Pins for Speaker, Microphone, PTT, and data communication lines.
Pins for car radio mute, horn alarm, ignition input, and sense inputs.
Shows connections for a junction box accessory.
Illustrates wiring for power, speaker, mic, and PTT connections.
Detailed wiring for MC6001 via junction box.
Direct connection of audio and power to the 25-pin connector.
Wiring diagram for connecting a Motorola GMN 6100A microphone.
Details mapping for a 16-wire Storno cable to the 25-pin connector.
Schematic diagram of the MC6001 microphone with internal amplifier.
Instructions on using the key to remove the radio from its holder.
Schematic for a circuit to override the 10-hour automatic shutdown feature.
General| Brand | Storno |
|---|---|
| Model | CQM6113 |
| Category | Cordless Telephone |
| Language | English |
To Next Page