StreamLabs
®
Control
Installation Guide
Contents
Installation Guidelines Part 1: Setup & Installation
Part 2: Setup & Installation
StreamLabs
®
Control
12V DC Power Adapter
3/4" and 1" come
with SharkBite
Disconnect Clips**
**1-1/4" Disconnect Clips can be purchased online
*Two spare included, only one per tting required for assembly
Gasket (4*)
Temporary Bypass Flow Tube
Close Button
Open Button
Wi-Fi Indicator LED
Wi-Fi Reset Button
9V Battery
Access Cover
(temporary
alternate
power only)
Power
Adapter
Plugin
NPT or SharkBite Unions (2)
• Failure to comply with all aspects of these instructions may result in unsafe
performance.
• All installations must comply with relevant State, Provincial and Local
Authority requirements.
• Control can be installed vertically or horizontally.
• If installing a Control with SharkBite
®
connections on copper pipe, use
appropriate grounding clamps and run a jumper wire across the unit.
• Only use the provided StreamLabs DC Power Adapter.
• The temporary bypass ow tube is for new construction or maintenance
applications of the Control.
• Max pressure at max temperature: 200 psi at 105° F.
• Control must be installed with correct ow direction as indicated on the
bottom of the unit.
1. Download the StreamLabs App.
2. Create an account or log in to an existing account.
3. Power your Control. The device should not be installed on pipe during initial
Wi-Fi pairing.
4. Follow the on-screen instructions in the app to setup and pair your device to
your wireless network.
5. Once Wi-Fi pairing is complete, unplug the Control, go to the installation
location and reference Part 2.
1. Locate your incoming cold water line.
The Control should be installed on the incoming water line aer a shut-o valve and a
pressure regulating valve. The Control is not meant to be used as the main shut-o valve to
the house. If you do not have a main shut-o valve or pressure regulating valve, install prior
to installing the Control.
Take note to install the Control prior to any pipe branches. Branches prior to the Control will
not be monitored or protected. At your installation location, you must have access to an
electrical outlet and a Wi-Fi signal. The Control comes with a DC power adapter with a 10
foot cord. Power adapters of additional lengths can be purchased from
StreamLabswater.com.
2.
Check your Wi-Fi strength at your installation location. If there is an inadequate
Wi-Fi signal:
a) Choose another location closer to your wireless router.
b) Relocate your wireless router closer to the installation.
c) Purchase a wireless extender to improve Wi-Fi coverage.
3. Shut o your incoming cold water line.
4. Drain your plumbing system.
5. If installing a Control with SharkBite connections refer to the pipe cut out table
below. If installing a Control with FNPT connections, thread your adapters (not
included) onto the unions and measure the cutout length.
Ball Valve
Cold Water to Home
PRV
Not MonitoredFlow Direction Monitored
Pipe Cut Out Table
6. Cut and remove pipe section. Ensure the pipe is cut clean, square, and is free
from any dirt or debris.
7. Install unions onto the cut sections of pipe. (If using SharkBite unions, refer to
the side 2 for How to Install a SharkBite Push-to-Connect Fitting)
8. Place a gasket into each union.
9. Insert the Control between the unions. Thread the unions by hand onto each
side of the Control. Tighten the union nuts with a wrench.
Make sure the device is installed with the directional arrow (found on the bottom of the
unit) pointing toward the direction of water ow.
10. Turn the water back on and check the installation.
11. Open a downstream faucet to ush air from your lines.
12. Plug the DC Power Adapter to an outlet and run the cable to power the
Control. The device will automatically reconnect to Wi-Fi and the Wi-Fi icon
will turn green.
13. Test the Control by opening and closing the valve using the touch panel on the
device.
14. Return to the StreamLabs App to complete setup.
Pipe Size SharkBite Pipe Cut Out Section
3/4 in. 8.5 in.
1 in. 10 in.
1-1/4 in. 10 in.
Copyright© 2019 all rights reserved by StreamLabs
®
• Terms of Service • Privacy Policy
To Next Page
Need help?
General
