2. The unit is equipped with a high-
capacity lithium polymer battery. If the
unit needs to be charged, the green
indicator light will flash quickly. To
charge the unit, turn it off and plug it
into the computer using the USB cable.
While the unit is charging, the indicator
light will flash red, then green, until the
battery is fully charged. Full charge will
be indicated by a steady green light.
Note: When charging the battery for the
first five times, charge the battery
completely after allowing it to discharge
fully. To completely charge, let it charge
for 30 minutes to an hour longer after
the steady green light comes on. This will
ensure that maximum battery life is
achieved.
F. Setting the Time
Connect DVR to an available USB port
on your computer. If the root directory
of the DVR does not appear on the
screen, you can double click on MY
COMPUTER (located on your desktop
or in your START menu), find the drive
letter of the DVR (usually the last
removable drive letter) Once you
have the root directory open, right click
anywhere in the folder (except on the
DCIM folder). From the menu that
opens select new and then select Text
document. You will now see
in the root
directory. You will need to name the
file “Time” and press the “enter” key
on your keyboard. Hint: You can right
click on the file and select “Rename”
from the menu that appears.
You will need to double-click on the file
“Time.txt”. Enter the date and time in
the following format: YYYY.MM.DD
<SPACE>HH:MM:SS
For example, 11/10/10 2:22 PM would
be entered as 2010.11.10 14:22:00
Save and close the file. Remove the
DVR from the USB port. Turn DVR
back on and the time will be set.
G. Webcam
This DVR can also be used as a web
camera (Webcam). To use this DVR as
a webcam hold down the picture /
motion-detection camera button (K2)
while connecting the unit to the
computer using the included USB
cable. If done correctly, you will see a
window open (Image download utility)
and can see a Standard Camera icon in
My Computer.
Note: If you are using the DVR as
webcam the first time you will need to
install the driver first using the
instructions below.
To use this item as a webcam you will
need to install the webcam driver
located on the included CD. Insert the
CD into your computer’s CD drive. Go
to the MY COMPUTER folder and
double click on the icon titled
Installation CD. You should now see an
icon titled Driver. Double click on the
icon titled Driver and the driver will be
installed. When you connect the DVR
to your computer to use it as a web
camera Windows will install the driver
for a “Standard Camera”.
PARAMETERS
To Previous Page
Loading...