EasyManua.ls Logo

Streetwize SWAC13 - Operating Instructions; Tyre Inflation Procedure; Inflating Other Items; Troubleshooting

Streetwize SWAC13
2 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Im
1.
2.
3.
4.
5.
6.
7.
8.
9.
10
11
1
N
C
C
Warning Avoid over-inflating. Never exceed the recommended pressure.
Items that are over inflated may burst and cause serious injury.
TROUBLE SHOOTING
Compressor does not start/blows fuses
1. Push the power plug firmly into the 12V power socket and twist it back and forth.
2. Check receptacle and plug terminals for dirt, particularly tobacco. Use a non-conductive probe,
not fingers or metal.
3. Check 12V power socket fuse. This should be 15 amps minimum.
4. Power cord unplugged.
Compressor runs but does not inflate
1. Be sure the connector is on the valve stem as far as possible before closing the thumb lock.
2. Check article for leaks.
3. Check hose for breaks and leaks at fittings.
Compressor runs slowly
1. Overheated from excessive use. Unplug power cord and leave it to cool for 30 minutes.
2. Voltage too low. Check condition of battery providing the power.
To inflate tyres
1. Move vehicle so that the tyre valve is on the bottom closest to the ground. Place the air compressor
next to the tyre.
2. Plug the power cord into the 12V power socket receptacle.
3. Place connector on tyre valve stem and push down as far as possible. Close the thumb lock.
4. When the correct pressure is reached on the analogue pressure gauge, unplug the power cord.
5. Remove adaptor from tyre valve, remove the power cord from the cigarette-lighter.
For other inflatables
1. Select the suitable adaptor (A & B for Inflatables & C for sports balls)
and insert it into the connector. Close thumb lock.
2. Check the owners manual for exact inflation pressures. Others are:
3. Insert adaptor into article to be inflated.
4. Plug power cord into 12V power socket receptacle.
5. When correct pressure is reached unplug power cord.
6. Remove adaptor from inflated article. Remove adaptor from connector.
7. Always check item being inflated with Streetwize pressure gauge. Avoid
excessive pressure in low pressure objects.
A
B
C
Streetwize Accessories:
Unit 1, Royce Trading Estate, Ashburton Road West,
Trafford Park, Manchester M17 1RY
Sales enquiries: sales@streetwizeaccessories.com
Technical enquiries: support@streetwizeaccessories.com
www.streetwizeaccessories.com
M17 1RY
SWAC13-Manual-2018.qxp_Layout 1 28/02/2019 14:56 Page 1