not start the engine until the fuel has completely evaporated.
- Do not start the lawnmower where you refueled. Make sure that the gasoline lawnmower is at a sufficient
distance from the place where you refueled (minimum 3 m).
- After adding fuel, securely tighten the fuel tank cap and the cap on the fuel canister.
- ATTENTION: Before carrying out maintenance or repairs, stop the engine and disconnect the spark plug.
ASSEMBLY AND OPERATION
UNPACKING
- Unpack the packaging and choose from it all parts that are supplied with the mower (e.g. instructions for
use, etc.) and store them in a safe place.
- Remove the lawnmower from the package and check that there are no parts left in the package.
- If any damage or missing parts are found, do not use the device and contact your dealer or authorized
service center.
- Before assembling and starting the gasoline lawnmower, read carefully the entire instructions manual and
the instructions in them.
ASSEMBLY
IMPORTANT INFORMATION: The lawnmower is supplied WITHOUT FUEL AND OIL in the engine. The
lawnmower was tested at the production plant meaning that a small amount of residual oil may be in the
engine.
Assembling the handle
- Carefully unfold the handle of the lawnmower, taking care not to damage the control cables of the mower.
1. Insert the bottom part of the handle into the respective hole on the lawnmower and secure in place with
4 screws (two screws on each side of the handle).
2. Attach the top part of the handle to the bottom part of the handle using the included screws with the
quick coupler and wing nuts.
Installing the handle panel
- Attach the plastic handle panel using the included screws.
Assembling the grass catcher
- Secure the plastic hooks at the end of the textile part of the grass catcher into the steel frame
- NOTE: The grass catcher is equipped with a level indicator (plastic flap at the back of the grass catcher).
- If the flap closes, the grass catcher must be emptied.
To Next Page
Loading...
