What to do if there's no AC power on my Striper Boat?
S
samuel54Jul 26, 2025
If there's no AC power, it could be due to several reasons. First, check if the main breaker(s) in the engine compartment are tripped or off, and turn them on or reset them. Next, inspect the breakers at the main AC panel and do the same. Also, ensure the shore power cord is securely connected; plug it in if necessary. Finally, check for loose or disconnected wires and tighten connections. If the problem persists, consult your dealer.
A
Adam FitzpatrickJul 31, 2025
What to do if 12 V device is not working on my Striper Seaswirl?
M
Mark SnowJul 31, 2025
If a 12V device isn't working, start by checking if the circuit breaker for the device is OFF and switch it to ON. Also, check if the battery is weak or dead; if so, change the battery selector switch position (if available) and charge the battery. Finally, inspect for faulty electrical connections and tighten or repair as needed.
H
Howard AustinAug 4, 2025
What to do if there is no power to AC devices on my Striper Boat?
V
Vicki LaneAug 4, 2025
If there's no power to your AC devices, first check the breakers at the main AC panel to see if they are tripped or off, and reset or turn them on. Verify the shore power cord is connected. If not, check the cord and plug it in. Look for any loose or disconnected wires and tighten the connections. If equipped, check the ground fault interrupter and reset the button on the outlet and test.
K
Kimberly JohnsonAug 8, 2025
Why is my Striper Boat battery not charging when the engine is running?
K
katiefowlerAug 8, 2025
If your battery isn't charging while the engine is running, the engine alternator belt might be loose. Tighten the belt to resolve this issue.
A
Andre JamesAug 12, 2025
What to do if there is no power to 12 V equipment on my Striper Boat?
W
Wanda AndrewsAug 12, 2025
If there's no power to your 12V equipment, first check if the battery disconnect switch is OFF and turn it ON. Then, verify the battery selector switch isn't turned to OFF; switch it ON for either the port (1) or starboard (2) battery. Lastly, if the battery is weak or dead, recharge it.
C
Christopher GuerreroAug 16, 2025
Why is my Striper Seaswirl Boat battery not holding a charge?
A
Andrew GeorgeAug 16, 2025
If your battery isn't holding a charge, it could be a bad battery. In this case, replace the battery.
D
Dean PerryAug 20, 2025
What to do if there is inadequate power to AC devices with generator running on my Striper Boat?
M
Michael TaylorAug 21, 2025
If you have inadequate power to AC devices while the generator is running, it might be because the electrical demand is greater than the generator output. Try switching off devices and equipment that are not needed.
To Next Page
General