How much can it pull?
Though many engines are possible, with a standard (196cc) Engine you can develop approximately 1/4
ton of “push or pull” at the rear mounted drawbar.
Where do I find other attachments?
STRUCK CORP. offers a universal Front Mounting Hitch (MB321) that allows the builder to use a popu-
lar Snow/Dirt Blade and Material Dump Bucket. In addition, we offer a Class 2 Rear Hitch Receiver KIT (MB311)
that fits all Class 2 attachments that are within the BEEP’s recommended load ability.
Can more than one person ride in the MINI-BEEP?
An optional Buddy Seat (MB320) is available to allow extra seating for a passenger. NOTE: The “gross
weight” of the operator, passenger and cargo can not exceed total payload weight of 350 lbs.
Will it get “water-logged” and sink?
By following the “Body Finishing Instructions” (page #B35), you will find instructions on the various meth-
ods to make your MINI-BEEP as water-proof as you want.
How stable is it in water?
The Body is very stable because of it’s “flat-bottom” construction. It’s actually a “unibody” assembled by
the Builder from panels of 3/4” thick exterior grade plywood. He either cuts the Body’s panels out of his own ply-
wood or uses the panels he purchased in our #1000 Plywood Body KIT. It draws approximately 8” of “draft” when
loaded with two passengers.
When driving the BEEP into water, do I need a nice smooth ramp or can I just “jump in”?
For maximum safety, you will want to chose a water entrance that is reasonably smooth with a modest in-
cline. You don’t want a site that is beyond the traction of your MINI-BEEP’s tires, nor steeper than the gradabil-
ity of your BEEP... check DVD’s for incline examples! Remember, it’s easy to go in water [you’re normally going
downhill]; much harder to get out [driving up a slippery bank]!
How do I buy my MINI-BEEP?
Nothing could be easier! Read the enclosed material. Determine your skill level and how involved you want
to be in your MINI-BEEP project. Decide which components you wish to provide yourself and those you’d prefer
to buy as a STRUCK-KIT®.
Fill out the MINI-BEEP Order Blank or call us for a Price Quote and a “no-obligation” freight estimate. In
a matter of a few weeks you’ll realize how easy it was to build your own “one of a kind” MINI-BEEP Amphibious
ORT!
How do you ship MINI-BEEP KITS?
Our large KITS, due to their weight, must be shipped via truck to a local freight terminal. They are palletized
for lift-truck handling. On arrival, the freight company can easily load them on your truck or trailer. When you ar-
rive home and cut the pallet’s banding, you will find that all the components can be easily handled by one per-
son.
NOTE: Smaller KITS, if purchased later, are shipped to your home or business via UPS.
Do you offer financing?
The STRUCK CORP. is not licensed to offer financing. Over the years we have found that folks can get
better loan terms by dealing with local loan officers where they have already established a good credit history. We
do accept Visa, Mastercard and Discover cards.
Can I build them for resale?
By purchasing this MBA80 Plans/Assembly Manual, you are licensed by the STRUCK CORP. to build (1)
one
MINI-BEEP Amphibious ORT. Your
Hull Identification Number
, included with this Manual, is your license to
build one MINI-BEEP following our Plans. To do otherwise would violate all applicable copyrights and patents.
E7
To Next Page
Loading...