EasyManuals Logo

Stryker Power-PRO XT Maintenance Manual

Stryker Power-PRO XT
186 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Hydraulic oil Stryker part number 6500-001-293
Power system
Battery 24 VDC NiCd - SSMMRRTT power system
Charger 100-240 VAC 1.20 A,
50/60 Hz or 12 VAC 4.16 A - SSMMRRTT power system
Cot duty cycle 16.7% (less than 60 seconds on, more than 300
seconds off)
Standards (cots and chargers) ANSI/AAMI ES60601-1:2012, CAN/CSA-C22.2 No.
60601-1:14, KKK-A-1822
For standards that require specific options, see
Standards with required options
(page 11).
1
Cot loads over 300 lb (136 kg) may require additional assistance to meet the set cot load height.
2
Height measured from bottom of mattress at seat section to ground level.
3
Cot is weighed with one battery and without mattress and restraints.
4
Set the cot height to any ambulance deck height that ranges from 26 in. to 36 in. (66 cm to 91 cm).
Stryker reserves the right to change specifications without notice.
PPoowweerr--PPRROO XT is designed to conform to the Federal Specification for the Star-of-Life Ambulance (KKK-A-1822).
PPoowweerr--PPRROO XT is designed to be compatible with some competitive cot fastener systems.
The yellow and black color scheme is a proprietary trademark of Stryker Corporation.
Hereby, Stryker declares that the radio equipment type short range device is in compliance with Directive 2014/53/EU. The
full text of the EU declaration of conformity is available at the following internet address: http://techweb.med.strykercorp.
com/EMS/EU%20Declaration%20of%20Conformity/index.html.
Labels may be unreadable from a viewing distance greater than 12 inches.
WWAARRNNIINNGG -- PPoowweerr--PPRROO with the PPoowweerr--LLOOAADD compatibility option operates primarily at these frequencies: 70 - 85 kHz
for inductive charging and 13.56 MHz±7 kHz, Amplitude Modulated (OOK), ERP: -82.37 dBm. The inductive charging can
operate between these frequencies: 70 - 125 kHz. Other equipment may interfere with the PPoowweerr--LLOOAADD system, even if
that other equipment complies with CISPR emission requirements.
EEnnvviirroonnmmeennttaall ccoonnddiittiioonnss
OOppeerraattiioonn SSttoorraaggee aanndd ttrraannssppoorrttaattiioonn
Temperature
130 °F
(54 °C)
-30 °F
(-34 °C)
130 °F
(54 °C)
-30 °F
(-34 °C)
Relative humidity
93%
0%
93%
0%
Atmospheric pressure
1060 hPa
700
1060 hPa
700
CCAAUUTTIIOONN -- This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at their expense.
EN 10 6506-109-002 Rev G.1

Other manuals for Stryker Power-PRO XT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stryker Power-PRO XT and is the answer not in the manual?

Stryker Power-PRO XT Specifications

General IconGeneral
ModelPower-PRO XT
CategoryMedical Equipment
Weight Capacity700 lbs (318 kg)
Power SourceBattery
Battery TypeSealed lead acid
Frame MaterialAluminum
HeightAdjustable
Minimum Height14 in (36 cm)
Wheels4
Incline CapabilityUnspecified
ControlHandheld
Safety FeaturesSide rails

Related product manuals