Need help?Do you have a question about the STUDIO DUE Parled 200 PRO IP67 and is the answer not in the manual?
Instructions to avoid fire hazards by maintaining safe distances and using correct fuses.
Safety procedures for electrical hazards, including earthing and power disconnection.
Safety steps for mechanical risks, such as using safety chains and handling hot surfaces.
Details on DMX, RDM, and optional wireless control interfaces.
Options for DMX modes, temperature control, and lighting effects.
IP rating, working temperature range, and power supply requirements.
Diagrams illustrating different DMX controller to fixture connection setups.
Warning regarding high voltage and the need to disconnect power before access.
Explains the importance of a DMX terminator resistor for line integrity.
Instructions for connecting and operating the DRS commander for fixture setup.
Meanings of displayed messages like 8888, Conn, and SCAn on the DRS.
Setting the DMX address and selecting the fixture's operation mode (Master/Slave).
Configuring speed, DMX channels, and enabling/disabling wireless reception.
General| IP Rating | IP67 |
|---|---|
| Power Consumption | 230W |
| Control Protocol | DMX, RDM |
| Voltage | 100-240V AC, 50/60Hz |
| Beam Angle | 15° |
To Next Page