4
Step Four
Step Five
6
Step Six
8
Turn keyboard stand to a standing position.
Adjust rollers on the legs evenly (+ - 5 mm)
with Cross screw driver in case of uneven floor.
6
4
Once dowels are in place and boards sit tight to the leg,
use metal corners (4) and M6 screws (6) to fix the
middle section to the leg.
Note! Turn the metal corner’s shorter edge
28 mm downward.
5
Carefully lift the left leg on top of the middle section
to match leg holes with the dowels. Ensure that every
dowel lines up with its corresponding hole on the leg.
Gently push the leg down until the middle section
seats together.
To Previous Page
Loading...