Stulz Ultra Series User Manual

STULZ Ultra-Series Humidifier Controller
(Augu
st, 2013) 47
5.7.9.1 Set Passwords
5.7.9.2 Factory Save Access
5.7.9.3 Factory Save
After the factory settings have been completed, they can
be save
d into permanent memory. It also should be saved
into the customer’s memory. This allows the restoration to
the factory settings, if the customer inadvertently sets up
situations that cause erratic behavior. By returning to this
screen the STULZ Product Support technician can restore
the settings back to the factory settings.
5.7.9.3.1 Initialization
This
screen is used to set the entire permanent memory
values back to their default values. This must be done any
time new software is downloaded. Use the Enter key to
position the cursor at the “No” text and then press either
the Up or Down key to start the initialization process. The
area labeled status will show the progress.
When it is done, it will go back to the Basic System
Configuration screen.
5.8 Factory Default Set Points
Table 1- Default Set Points
Parameter Set Point
Remote Enable Yes
Customer Alarm 1 Enable No
Airflow Enable No
BMS keep alive Override No
Smoke Alarm Enable No
High humidity Switch Enable No
Customer Alarm 2 Enable No
Humidifier Temperature Enable No
Customer Alarm 3 Enable No
Group Select No
Cabinet Fan Enable Yes
Custom Alarm 1 Output Enable No
Custom Alarm 2 Output Enable No
Custom Alarm 3 Output Enable No
Custom Alarm 4 Output Enable No
Log Remote Shutdown No
Bank Enable No
High Airflow Alarm Enable No
Low Airflow Alarm Enable No
High limit humidity alarm Enable No
Control Temperature Enable No
Control Humidity Enable Yes
Conductivity Enable Yes
Limit Temperature Enable No
Limit Humidity Enable No
Airspeed Enable No
Low Limit Humidity Alarm Enable No
NTC2 Temperature Sensor Enable No
NTC3 Temperature Sensor Enable No
NTC4 Temperature Sensor Enable No
Control Temperature X Low Scale 0
Control Temperature X High Scale 50.0
Control Humidity X Low Scale 0
Control Humidity X High Scale 100.0
Limit Temperature X Low Scale 0
Limit Temperature X High Scale 50.0
Limit Humidity X Low Scale 0
Limit Humidity X High Scale 100.0
Remote On/OFF Invert Yes
Customer Alarm 1 Invert Yes
Airflow Switch Invert Yes
Water Detector Invert Yes
Smoke Alarm Invert Yes
High Humidistat Invert Yes
Customer Alarm 2 Invert Yes
Freeze Alarm Invert Yes
Control: 1
Service: 2
Factory: xxxxx
Config: xxxxx
Set Passwords
Password Config
FACT SAVE
Initialize Variables
software details that are
MUST SAVE BOTH FACTORY
AND CUSTOMER VALUES
Save Factory No
Save Customer No
Restore Factory No
Factory Save
DEFAULT INITIALIZATION
Erase user settings
and install global
default values: No
status
Initialization

Stulz Ultra Series Specifications

General

Brand	Stulz
Model	Ultra Series
Category	Controller
Language	English