PAGE 2 STUV 21 | MODEL SPECIFICATIONS
^
1. PRELIMINARY INSTALL INFORMATIONS
In relation to the installation and use of this appliance, the installer and the user should strictly
adhere to local and national regulations as well as Australian & New Zealand Standards AS/NZS
2918:2001. They should also follow the instructions detailed in the Stuv 21 installation and user
manual. Safe operation of the fireplace is directly dependent thereon. The liability of the manufacturer
can neither be retained nor assured following failure of installation or incorrect use which is not
compliant with AS/NZS 2918:2001.
As each installation is different, a qualified and licensed trades professional should take all required
preliminary precautions depending on the technical elements inherent to each job.
In-observance of the assembly instructions in conjunction with AS/NZS 2918:2001 entails the liability
of the person who carries it out.
Fireplace structure and finishes shall be to your own design providing the exact and minimum
dimensions are maintained.
The floor must have adequate strength to support the fireplace. N.B. Timber floors may require
additional reinforcing.
Construction of the fireplace structure from floor to ceiling shall be: solid brick (110mm minimum),
Silca 250KM board (40mm), stone (100mm minimum) or Hebel aerated blocks (150mm minimum).
When installed on a combustible floor surface the Stuv 21 firebox must be fitted on a raised platform
(height 150mm minimum) constructed of non combustible materials.
As a result of faulty assembly, use of parts or additional components not supplied by the
manufacturer/distributor, and/or modifying of the appliance or components will result in inferior or
unsafe operation. Should this occur the manufacturer/distributor bears no liability, and will result in a
null and void product warranty.
To Next Page
Loading...
