Features of Smart Battery Clamp
1. Battery voltage detection: If the detected voltage is abnormal, alarm
would be set off (the red Indicator light stays on and the buzzer beeps)
and the output would be turned off automatically.
2. Reverse polarity protection: If the clamps are connected to the wrong
polarities, alarm would be set off (the red indicator light stays on and the
buzzer beeps) and the output would be turned off automatically.
3. Detect defective battery: If the vehicle battery is severely damaged,
alarm would be set off (the red indicator light stays on and the buzzer
beeps) and the output would be turned off automatically.
4. Reverse charging protection.
5. BOOST button (force start function).
Operation Guidance
·Indicator
Press the power button to check the battery level of this product.
The indicator will flash one by one during charging.
The different number of light indicators show the different battery level of
this product. All indicators light will be off when the charging is paused or
completed.
·Low Battery Protection
When you are using the USB ports or flashlight, the power indicator lights
would display the remaining battery level. When only one power indicator
light blinks, the product has a low battery level and needs to be charged
immediately. If all power indicator lights go off when you are using the
product, the protection mechanism is triggered due to low battery level.
·Charging this Product
1. Plug the USB cable to any working USB-A power adapter.
2. Connect the USB connector to the Quick Charge input port of this
product.
Note:
1. Do NOT charge the jump starter immediately after using it to jump start a
vehicle or while it is still hot.
2. Do NOT connect with the smart battery clamp while the jump starter is
charging.
3. It is recommended not to exceed 10 hours of the charging time.
4. Do NOT charge the jump starter via a USB-A power adapter from
non-normalized manufacturers. Otherwise, the charging may be limited
or could not be fully charged.
·Jump Start a 12V Vehicle
Before jump start, please make sure the battery level of the jump starter is
over 50%, otherwise, you may not be able to jump start the vehicle.
1. Connect the battery clamp fully seated into the jump start socket. If the
green light and red light are flashing alternatively, this indicates that the
battery of the jump starter can work properly. If the battery cannot work
properly, the red light of the smart battery clamp will be on with buzzing.
EN-4
To Next Page
Loading...
