14
LIGHTING INFORMATION
IMPORTANT NOTE:
When the refrigerator or
freezer doors are left open for a long time, the
lights may go off. This protects the internal parts
from overheating. To reset the light system,
close the door for 15 to 30 minutes.
Your Sub- Zero Built -In u nit c ontai ns un ique 40
watt appliance bulbs (7009935) in refrigerator
and freezer sections.
IMPORTANT NOTE:
To r eplac e a light bulb , dis-
connect power supply from the receptacle before
changing light bulb. The power cord is located in
the far right corner behind the flip-up grille.
SUB-ZERO BUILT-IN USE & CARE
Overhead light shield removal
OVERHEAD LIGHTING
You’ ll ne ed to r emove the li ght s hield i n the top
of the refrigerator or freezer to replace the bulbs.
Place your hands under the light shield and slide
back slowly until the key slots on the sides of the
light shield drop past the mounting studs in the
upper brackets. Then remove the shield. The
bulbs are now accessible. Refer to the illustration
below.
Models ICBBI-36RG, ICBBI-30UG and
ICBBI-36UG:
Like all Sub-Zero units, lights in
glass door models will fully illuminate when the
door is open. With the ICBBI-36RG, ICBBI-30UG
and ICBBI-36UG, however, you have the option
of having subdued lighting even with the door
closed. You can easily turn this feature off by
depressing the key pad on the Control
Center. The indicator will appear when
accent lights are enabled.
CRISPER LIGHTING
Crisper drawer lighting is located behind the
upper crisper drawer and mounted to the back
wall of the refrigerator. To remove the light
shield first remove the crisper drawer. Next
remove the upper crisper shelf. Then place both
hands under the bottom right and left sides of
the light shield and push upward.
See illustration below.
FREEZER LIGHTING
Models ICBBI-30U, ICBBI-30UG, ICBBI-36U
and ICBBI-36UG:
Freezer lighting is located in
upper front section of the freezer compartment.
To r emov e the lig ht sh ield, g entl y com pres s the
shield to release it from the supporting guides.
Models ICBBI-42S and ICBBI-48S:
Freezer
basket lighting is located above the ice bucket.
To a cces s the bul bs, r emov e the ice buck et. N ext,
push the ice bucket assembly to the back of the
unit. Once the assembly is against the back wall
of the unit, the bulb will be accessible under the
fixed shelf in front of the icemaker.
Models ICBBI-42SD and ICBBI-48SD:
Freezer
lighting above the ice bucket is accessible by
removing the ice bucket. See Ice Bucket
Removal, page 9. Once the bucket has been
removed, remove the light shield. See Overhead
Lighting, page 14.
Freezer lighting below the Ice bucket is acces-
sible by removing the glass light shield. To
remove the glass, press the plastic lip up and
pull the glass out of the supporting guides.
Freezer basket lighting is located below the fixed
shelf on the back wall of the freezer. To access
the light first remove the freezer basket below
the fixed shelf. To remove the light shield, gently
compress the shield to release it from the sup-
porting guides.
Light shield removal—crisper
ACCESSORIES
Optional acces-
sories are available
through your
Sub-Zero dealer. To
obtain local dealer
information, visit
our website,
subzero.com.
Disconnect power supply from the receptacle
before changing light bulb. Wear protective
gloves when handling bulbs.
CAUTION
To Next Page
Loading...
Need help?
General
